IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAA network administrator is having issues with a newly installed network not appearing in other routers. At which layer of the OSI model is the network administrator going to start the troubleshooting process when using a top-down approach?ITExamAnswers asked 4 years ago • CCNAWhich category of software troubleshooting tools provides device-level monitoring, configuration, and fault-management?ITExamAnswers asked 4 years ago • CCNAWhich two specialized troubleshooting tools can monitor the amount of traffic that passes through a switch? (Choose two.)ITExamAnswers asked 4 years ago • CCNAThe newly configured ASBR that connects a company to the Internet has a default route configured and has the default-information originate command entered. Devices connected through this router can access the Internet. The problem is that no other OSPF routers have a default route in the routing table and no other users throughout the organization can access the Internet. What could be the problem?ITExamAnswers asked 4 years ago • CCNAAn internal corporate server can be accessed by internal PCs, but not by external Internet users that should have access. What could be the issue?ITExamAnswers asked 4 years ago • CCNAFill in the blank. Use the cache to verify IPv4 address to Layer 2 Ethernet address mappings on a host computer.ITExamAnswers asked 4 years ago • CCNAOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. A user reports that PC0 cannot visit the web server www.server.com. Troubleshoot the network configuration to identify the problem. What is the cause of the problem?ITExamAnswers asked 4 years ago • CCNAWhat is a purpose of the network command when configuring RIPv2 as the routing protocol?ITExamAnswers asked 4 years ago • CCNAA network administrator configures a static route on the edge router of a network to assign a gateway of last resort. How would a network administrator configure the edge router to automatically share this route within RIP?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which two types of routes could be used to describe the 192.168.200.0/30 route? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhich route would be automatically created when a router interface is activated and configured with an IP address?ITExamAnswers asked 4 years ago • CCNAWhat occurs next in the router lookup process after a router identifies a destination IP address and locates a matching level 1 parent route?ITExamAnswers asked 4 years ago • CCNAWhich two requirements are used to determine if a route can be considered as an ultimate route in a router’s routing table? (Choose two.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Based on the partial output from the show ip route command, what two facts can be determined about the RIP routing protocol? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhile configuring RIPv2 on an enterprise network, an engineer enters the command network 192.168.10.0 into router configuration mode. What is the result of entering this command?ITExamAnswers asked 4 years ago • CCNA