IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
What tool is important to consider for use when making hardware improvement decisions about switches?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the maximum wire speed of a single port on a 48-port gigabit switch?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
When the installation of a network infrastructure is being planned, which technology will allow power to be provided via Ethernet cabling to a downstream switch and its connected devices?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Match the function to the corresponding switch type. (Not all options are used.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Fill in the blank. How many collision domains are shown in the topology? 2
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Match the borderless switched network guidline description to the principle (not all options used)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Why are the pings from PC0 to Server0 not successful?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. What IPv6 static route can be configured on router R1 to make a fully converged network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Consider that the main power has just been restored. PC3 issues a broadcast IPv4 DHCP request. To which port will SW1 forward this request?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What two criteria are used by a Cisco LAN switch to decide how to forward Ethernet frames? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the destination address in the header of a broadcast frame?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Fill in the blank. A converged* network is one that uses the same infrastructure to carry voice, data, and video signals.
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Fill in the blank.
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…145146147148149…167Next »
Ask Question