IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNARefer to the exhibit. A network administrator needs to configure router-on-a-stick for the networks that are shown. How many subinterfaces will have to be created on the router if each VLAN that is shown is to be routed and each VLAN has its own subinterface?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?ITExamAnswers asked 4 years ago • CCNAWhich four steps are needed to configure a voice VLAN on a switch port? (Choose four).ITExamAnswers asked 4 years ago • CCNAPort Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator has configured router CiscoVille with the above commands to provide inter-VLAN routing. What command will be required on a switch that is connected to the Gi0/0 interface on router CiscoVille to allow inter-VLAN routing?ITExamAnswers asked 4 years ago • CCNAWhat is a characteristic of a routed port on a Layer 3 switch?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PC2 cannot communicate with PC1. Based on the output, what is the possible cause of the problem?ITExamAnswers asked 4 years ago • CCNAIdentify the steps needed to configure a switch for SSH. The answer order does not matter. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAIf one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?ITExamAnswers asked 4 years ago • CCNAWhich command is used to set the BOOT environment variable that defines where to find the IOS image file on a switch?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. How many broadcast domains are displayed?ITExamAnswers asked 4 years ago • CCNAWhich command displays information about the auto-MDIX setting for a specific interface?ITExamAnswers asked 4 years ago • CCNAWhich subnet would include the address 192.168.1.96 as a usable host address?ITExamAnswers asked 4 years ago • CCNAConsider the following range of addresses:ITExamAnswers asked 4 years ago • CCNAA network team is comparing physical WAN topologies for connecting remote sites to a headquarters building. Which topology provides high availability and connects some, but not all, remote sites?ITExamAnswers asked 4 years ago • CCNA