IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNASwitch SW1 has been configured to use Dynamic ARP Inspection with DHCP Snooping in VLAN 5. An ARP request arrives on port G0/1. Which answer describes two items DAI always compares regardless of the configuration?ITExamAnswers asked 2 years ago • CCNASwitch SW1 needs to be configured to use DHCP Snooping in VLAN 5 and only VLAN 5. Which commands must be included, assuming at least one switch port in VLAN 5 must be an untrusted port? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNALayer 2 switch SW2 connects a Layer 2 switch (SW1), a router (R1), a DHCP server (S1), and three PCs (PC1, PC2, and PC3). All PCs are DHCP clients. Which of the following are the most likely DHCP Snooping trust state configurations on SW2 for the ports connected to the listed devices? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAOn a multilayer switch, a switch needs to be configured to perform DHCP Snooping on some Layer 2 ports in VLAN 3. Which command may or may not be needed depending on whether the switch also acts as a DHCP relay agent?ITExamAnswers asked 2 years ago • CCNAAn engineer hears about DHCP Snooping and decides to implement it. Which of the following are the devices on which DHCP Snooping could be implemented? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAWhich of the following commands on a Windows OS should list both the IP address and DNS servers as learned with DHCP?ITExamAnswers asked 2 years ago • CCNAIn the following excerpt from a command on a Mac, which of the following parts of the output represent information learned from a DHCP server? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAA router connects to an Internet Service Provider (ISP) using its G0/0/0 interface, with the ip address dhcp command configured. What does the router do with the DHCPlearned default gateway information?ITExamAnswers asked 2 years ago • CCNAWhich answers list a criterion for choosing which router interfaces need to be configured as a DHCP relay agent? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAWhich of the following kinds of information are part of a DHCP server configuration? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAA PC connects to a LAN and uses DHCP to lease an IP address for the first time. Of the usual four DHCP messages that flow between the PC and the DHCP server, which ones do the client send? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAA switch’s port Gi0/1 has been correctly enabled with port security. The configuration sets the violation mode to restrict. A frame that violates the port security policy enters the interface, followed by a frame that does not. Which of the following answers correctly describe what happens in this scenario? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAThe show port-security interface f0/1 command lists a port status of secure-down. Which one of the following answers must be true about this interface at this time?ITExamAnswers asked 2 years ago • CCNAWhich of the following commands list the MAC address table entries for MAC addresses configured by port security? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAA Cisco Catalyst switch connects to what should be individual user PCs. Each port has the same port security configuration, configured as follows: Which of the following answers describe the result of the port security configuration created with these commands? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNA