IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAExamine the following show command output on a router configured for dynamic NAT: Users are complaining about not being able to reach the Internet. Which of the following is the most likely cause?ITExamAnswers asked 2 years ago • CCNAExamine the following configuration commands: If the configuration is intended to enable source NAT overload, which of the following commands could be useful to complete the configuration? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNANAT has been configured to translate source addresses of packets for the inside part of the network, but only for some hosts as identified by an access control list. Which of the following commands indirectly identifies the hosts?ITExamAnswers asked 2 years ago • CCNAWith dynamic NAT, performing translation for inside addresses only, what causes NAT table entries to be created?ITExamAnswers asked 2 years ago • CCNAWith static NAT, performing translation for inside addresses only, what causes NAT table entries to be created?ITExamAnswers asked 2 years ago • CCNAWhich of the following are not private addresses according to RFC 1918? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAWhich of the following summarized subnets represent routes that could have been created for CIDR’s goal to reduce the size of Internet routing tables?ITExamAnswers asked 2 years ago • CCNAA switch is cabled to a router whose host name is Hannah. Which of the following LLDP commands could identify Hannah’s model of hardware? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAImagine that a switch connects through an Ethernet cable to a router, and the router’s host name is Hannah. Which of the following commands could tell you information about the IOS version on Hannah without establishing a Telnet connection to Hannah? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAThe only NTP configuration on router R1 is the ntp server 10.1.1.1 command. Which answers describe how NTP works on the router?ITExamAnswers asked 2 years ago • CCNAWhich of the following is accurate about the NTP client function on a Cisco router?ITExamAnswers asked 2 years ago • CCNAWhat command limits the messages sent to a syslog server to levels 4 through 0?ITExamAnswers asked 2 years ago • CCNAWhat level of logging to the console is the default for a Cisco device?ITExamAnswers asked 2 years ago • CCNAA Layer 2 switch needs to be configured to use Dynamic ARP Inspection along with DHCP Snooping. Which command would make DAI monitor ARP message rates on an interface at an average rate of 4 received ARP messages per second? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNASwitch SW1 needs to be configured to use Dynamic ARP Inspection along with DHCP Snooping in VLAN 6 and only VLAN 6. Which commands must be included, assuming at least one switch port in VLAN 6 must be a trusted port? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNA