IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich of the following was a short-term solution to the IPv4 address exhaustion problem?ITExamAnswers asked 2 years ago • CCNAPer the command output, with how many routers is router R9 full adjacent over its Gi0/0 interface?ITExamAnswers asked 2 years ago • CCNARouters R1 and R2, with router IDs 1.1.1.1 and 2.2.2.2, connect over an Ethernet WAN link. The configuration uses all defaults, except giving R1 an interface priority of 11 and changing both routers to use OSPF network type point-to-point. If the WAN link initializes for both routers at the same time, which of the following answers are true? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNARouters R1 and R2, with router IDs 1.1.1.1 and 2.2.2.2, connect over an Ethernet WAN link. If using all default OSPF settings, if the WAN link initializes for both routers at the same time, which of the following answers are true? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAOSPF interface configuration uses the ip ospf process-id area area-number configuration command. In which modes do you configure the following settings when using this command?ITExamAnswers asked 2 years ago • CCNAWhich of the following configuration settings on a router does not influence which IPv4 route a router chooses to add to its IPv4 routing table when using OSPFv2?ITExamAnswers asked 2 years ago • CCNAAn engineer migrates from a more traditional OSPFv2 configuration that uses network commands in OSPF configuration mode to instead use OSPFv2 interface configuration. Which of the following commands configures the area number assigned to an interface in this new configuration?ITExamAnswers asked 2 years ago • CCNAWhich of the following commands list the OSPF neighbors off interface serial 0/0? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNAWhich of the following network commands, following the command router ospf 1, tells this router to start using OSPF on interfaces whose IP addresses are 10.1.1.1, 10.1.100.1, and 10.1.120.1?ITExamAnswers asked 2 years ago • CCNAWhich of the following network commands, following the command router ospf 1, tells this router to start using OSPF on interfaces whose IP addresses are 10.1.1.1, 10.1.100.1, and 10.1.120.1?ITExamAnswers asked 2 years ago • CCNAA company has a small/medium-sized network with 15 routers and 40 subnets and uses OSPFv2. Which of the following is considered an advantage of using a single-area design as opposed to a multiarea design?ITExamAnswers asked 2 years ago • CCNAWhich of the following OSPF neighbor states is expected when the exchange of topology information is complete between two OSPF neighbors?ITExamAnswers asked 2 years ago • CCNATwo routers using OSPFv2 have become neighbors and exchanged all LSAs. As a result, Router R1 now lists some OSPF-learned routes in its routing table. Which of the following best describes how R1 uses those recently learned LSAs to choose which IP routes to add to its IP routing table?ITExamAnswers asked 2 years ago • CCNAWhich of the following interior routing protocols support VLSM? (Choose three answers.)ITExamAnswers asked 2 years ago • CCNAWhich of the following routing protocols use a metric that is, by default, at least partially affected by link bandwidth? (Choose two answers.)ITExamAnswers asked 2 years ago • CCNA