IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Refer to the exhibit. Which two commands must be configured on router R1 to enable the router to accept secure remote-access connections? (Choose two)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which protocol is used for secure remote CLI access?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is a requirement for nonoverlapping Wi-Fi channels?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network engineer must update the configuration on Switch2 so that it sends LLDP packets every minute and the information sent via LLDP is refreshed every 3 minutes Which configuration must the engineer apply?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
OSPF must be configured between routers R1 and R2. Which OSPF configuration must be applied to router R1 to avoid a DR/BDR election?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which type of IPv6 address is similar to a unicast address but is assigned to multiple devices on the same network at the same time?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is the purpose of the ip address hcp command?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which type of API allows SDN controllers to dynamically make changes to the network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is a function of a Layer 3 switch?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. The entire MAC address table for SW1 is shown here: What does SW1 do when Br-4 sends a frame to Br-2?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which device permits or denies network traffic based on a set of rules?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What will a router do if it does not have a default route configured and a packet needs to be forwarded to a destination network that is not listed in the routing table?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network administrator has entered the following command: ip route 192.168.10.64 255.255.255.192 serial0/0/1 When the network administrator enters the command show ip route, the route is not in the routing table. What should the administrator do next?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator notices that a correctly entered static route is not in the routing table. What two router commands would an administrator use to determine if the exit interface was up and the next hop address is available? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network engineer issues the show cdp neighbor command on several network devices during the process of network documentation. What is the purpose of performing this command?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…6768697071…167Next »
Ask Question