IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Which statement describes the sequence of processes executed by a router when it receives a packet from a host to be delivered to a host on another network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A static route has been configured on a router. However, the destination network no longer exists. What should an administrator do to remove the static route from the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which sequence correctly identifies the order of the steps that a router will perform when it receives a packet on an Ethernet interface?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Which type of static route typically uses the distance parameter in the ip route global configuration command?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Which IPv6 static route would serve as a backup route to a dynamic route learned through OSPF?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is the purpose of a floating static route?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is a characteristic of a default static route? ​
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which command would create a valid IPv6 default route?
IT Questions Bank 11IT Administrator asked 4 years ago • 
A network administrator is configuring a route to forward packets to a specific web server. What type of route should be configured by the administrator?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which static route statement shows a recursive IPv6 static route?
IT Questions Bank 11IT Administrator asked 3 years ago • ,
A network administrator uses the command ip route 172.18.0.0 255.255.0.0 S0/0/1 to configure a floating static route on a router. That route will function as a backup route to reach the EIGRP learned network 172.18.0.0/16. After this configuration, the EIGRP route is removed from the routing table even though EIGRP is still functioning properly. Why is the static route not functioning as intended?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network administrator configures a router by the command ip route 0.0.0.0 0.0.0.0 209.165.200.226. What is the purpose of this command?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What are two reasons why an administrator might choose to use static routing rather than dynamic routing? (Choose two.)
IT Questions Bank 11IT Administrator asked 3 years ago • 
« Previous1…6869707172…167Next »
Ask Question