IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich nonproprietary protocol provides router redundancy for a group of routers which support IPv4 LANs?ITExamAnswers asked 4 years ago • CCNAA network administrator is entering the command ipv6 unicast-routing to start configuring DHCPv6 operation on a router. Which statement describes the function of this command?ITExamAnswers asked 4 years ago • CCNAAfter booting, a client receives an ICMPv6 RA message with the M flag set to 0 and the O flag set to 1. What does this indicate?ITExamAnswers asked 2 years ago • CCNAWhat process is used in ICMPv6 for a host to verify that an IPv6 address is unique before configuring it on an interface?ITExamAnswers asked 2 years ago • CCNA, CCNA CyberOpsIn which alternative to DHCPv6 does a router dynamically provide IPv6 configuration information to hosts?ITExamAnswers asked 2 years ago • CCNAWhich destination IP address is used when an IPv6 host sends a DHCPv6 SOLICIT message to locate a DHCPv6 server?ITExamAnswers asked 3 years ago • CCNA, CCNPWhat message informs IPv6 enabled interfaces to use stateful DHCPv6 for obtaining an IPv6 address?IT Administrator asked 4 years ago • CCNA CyberOps, CCNAWhich command should be configured on a router interface to set the router as a stateful DHCPv6 client?ITExamAnswers asked 2 years ago • CCNAA client is using SLAAC to obtain an IPv6 address for its interface. After an address has been generated and applied to the interface, what must the client do before it can begin to use this IPv6 address?ITExamAnswers asked 4 years ago • CCNAWhat two methods can be used to generate an interface ID by an IPv6 host that is using SLAAC? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is the most likely scenario in which the WAN interface of a router would be configured as a DHCP client to be assigned a dynamic IP address from an ISP?ITExamAnswers asked 4 years ago • CCNAWhat kind of message is sent by a DHCPv4 client requesting an IP address?IT Administrator asked 4 years ago • CCNA CyberOps, CCNAWhen a client is requesting an initial address lease from a DHCP server, why is the DHCPREQUEST message sent as a broadcast?ITExamAnswers asked 4 years ago • CCNAAn administrator issues the commands: Router(config)# interface g0/1 Router(config-if)# ip address dhcp What is the administrator trying to achieve?ITExamAnswers asked 4 years ago • CCNAWhen a range of ports is being configured for EtherChannel, which mode will configure LACP on a port only if the port receives LACP packets from another device?ITExamAnswers asked 4 years ago • CCNA