IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP 300-410
Refer to the exhibit. An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. An engineer has configured policy-based routing and applied the configuration to the correct interface. How is the configuration applied to the traffic that matches the access list?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. Which set of commands restore reachability to loopback0?
IT Questions Bank 2IT Administrator asked 2 years ago • 
A network administrator performed a Compact Flash Memory upgrade on a Cisco Catalyst 6509 Switch. Everything is functioning normally except SNMP, which was configured to monitor the bandwidth of key interfaces but the interface indexes are changed. Which global configuration resolves the issue?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. AS111 is receiving its own routes from AS200 causing a loop in the network. Which configuration provides loop prevention?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. A network is under a cyberattack. A network engineer connected to R1 by SSH and enabled the terminal monitor via SSH session to find the source and destination of the attack. The session was flooded with messages, which made it impossible for the engineer to troubleshoot the issue. Which command resolves this issue on R1?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. AS65510 BGP is configured for directly connected neighbors. R4 cannot ping or traceroute network 192.168.100.0/24. Which action resolves this issue?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. An engineer configured SNMP communities on the Core Sw1, but the SNMP server cannot obtain information from Core_Sw1. Which configuration resolves this issue?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. Which action resolves the adjacency issue?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Refer to the exhibit. Which two commands provide the administrator with the information needed to resolve the issue? (Choose two.)
IT Questions Bank 2IT Administrator asked 2 years ago • 
What is a characteristic of Layer 3 MPLS VPNs?
IT Questions Bank 2IT Administrator asked 2 years ago • 
What does the MP-BGP OPEN message contain?
IT Questions Bank 2IT Administrator asked 2 years ago • 
What statement about route distinguishes in an MPLS network is true?
IT Questions Bank 2IT Administrator asked 2 years ago • 
The network administrator configured R1 for Control Plane Policing so that the inbound Telnet traffic is policed to 100 kbps. This policy must not apply to traffic coming in from 10.1.1.1/32 and 172.16.1.1/32. The administrator has configured this: The network administrator is not getting the desired results. Which set of configurations resolves this issue?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Which mechanism provides traffic segmentation within a DMVPN network?
IT Questions Bank 2IT Administrator asked 2 years ago • 
« Previous1234…6Next »
Ask Question