IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNP ROUTE v6.0Refer to the exhibit. The EIGRP subnets such as 10.10.0.0/16 and 10.20.0.0/16 are not being seen inside the OSPF domain. What is a possible reason for this?ITExamAnswers asked 1 year ago • CCNP ROUTE, CCNP ROUTE v6.0Which command would deploy a prefix list in a BGP environment?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which is the default seed metric for an OSPF route that is redistributed into an EIGRP autonomous system?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. The network that is shown is operating normally with the routing protocols configured with the default settings. What path will packets from PC1 take to the file server?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which command would allow advertising only an aggregate address of 192.168.0.0/16 when applied by using a neighbor statement that contains prefix-list [prefix-list name] out?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. Which command was issued to display the route metric and minimum MTU information that is shown?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. A network engineer was called to investigate some intermittent delay and jitter issues with the corporate network that is shown. The engineer determined that the root cause is that the routing tables in the district routers are so large that the routers cannot maintain the tables efficiently. What can be done to mitigate this issue?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which method of redistribution is least likely to introduce a routing loop into a network?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which prefix-list entry will be used when multiple entries in a prefix list match a given prefix?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTE v6.0What is the final step when configuring policy-based routing?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTE v6.0Refer to the exhibit. RTA has two paths to network 10.0.0.0/8 via two serial links, Serial 0/0/0 to RTB and Serial 0/0/1 to RTC. RTA is not running any dynamic routing protocol and its preferred route to network 10.0.0.0/8 is via RTC. Which commands on RTA would configure it to use RTB to reach network 10.0.0.0/8 only if the serial link to RTC fails?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Refer to the exhibit. Two-way redistribution was configured between OSPF and RIP on R2. After the redistribution, R3 does not see any external routes coming from the RIP domain. The debug ip ospf database external output reveals that no external LSAs are generated for the routes. What could the problem be?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0Which command can be used to determine the stability of an OSPF area by examining the number of times SPF has been executed for that area?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0What is the correct method to configure route summarization on an OSPF router?IT Administrator asked 2 years ago • CCNP, CCNP ROUTE v6.0How can correct OSPF topology change-behavior be verified as part of an implementation plan?ITExamAnswers asked 11 months ago • CCNP ROUTE v6.0