IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNP ROUTEWhich of the following statements are true regarding OSPFv3? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEIn which two types of areas will the ABR forward LSA 3s into an area? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two statements are true abut interarea and intraarea routes in multiarea OSPF? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEIn an OSPF hubandspoke topology, what needs to be done to ensure that the spoke routers would never be selected as DR and BDR? All spoke routers need to be configured with an OSPF interface priority of 0 (ip ospf priority) so that they will not become the DR/BDR.* All routers must be configured with an OSPF interface priority of 0 (ip ospf priority) to disable the DR/BDR election process. Because nonbroadcast networks do not elect a DR/BDR, nothing needs to be done. One of the spoke routers will need to be configured as the DR by setting the OSPF interface priority higher than 1 (ip ospf priority).ITExamAnswers asked 1 year ago • CCNP ROUTEWhat does OSPF use to reduce the number of exchanges of routing information in networks where large numbers of neighbors are present? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNP ROUTEA network administrator is planning an OSPF implementation and must ensure proper router DR/BDR assignments. What is the default interface priority value for OSPF routers?ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. What does the state “FULL/ -” indicate?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNP ROUTERefer to the diagram. Which state is RTB in if it sees itself in the RTA hello but no routing information has been exchanged?ITExamAnswers asked 1 year ago • CCNP ROUTEFor OSPF, which three options must be the same within the hello packet that is exchanged between two adjacent routers? (Choose three.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two statements are true about multiarea OSPF? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhat does the Cisco IOS use to calculate the OSPF cost to a destination network?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich of the following statements are correct regarding named EIGRP configuration? (Choose three.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich statement is not correct regarding named EIGRP configuration?ITExamAnswers asked 1 year ago • CCNP ROUTERouter R1’s GigabitEthernet 0/0 is configured with the IPv6 address 2001:DB8:CAFE:1::1/64. Which of the following would enable EIGRP for IPv6, with an AS of 1, on this interface?ITExamAnswers asked 1 year ago • CCNP ROUTEWhen implementing EIGRP unequal cost load balancing using the variance command, which two conditions must be met? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTE