IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
An administrator is troubleshooting an OSPFv3 network. Router A and router B are configured with IPv6 addressing and basic routing capabilities using OSPFv3. While debugging the routing process, the administrator discovers that the networks that are advertised from router A do not show in the routing table of router B. Why is the routing information not being learned by router B?
IT Questions Bank 2IT Administrator asked 3 years ago • 
How is the flooding scope of link state advertisements denoted within OSPFv3 LSAs?
IT Questions Bank 2IT Administrator asked 3 years ago • 
What are three types of IP packets that require process switching and cannot be forwarded by CEF in a Cisco router? (Choose three.)
IT Questions Bank 2IT Administrator asked 2 years ago • 
Which type of OSPF link-state advertisement is an ASBR summary LSA?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Match the DTP mode with its function. (Not all options are used.)
IT Questions Bank 6ITExamAnswers asked 4 years ago • ,
How do WLCs in a mobility group identify each other?
IT Questions Bank 2IT Administrator asked 2 years ago • 
Which two statements are true about WRED? (Choose two.)
IT Questions Bank 6ITExamAnswers asked 4 years ago • 
How do Layer 3 switches differ from traditional routers?
IT Questions Bank 6ITExamAnswers asked 3 years ago • 
What function is performed by the OSPF designated router?
IT Questions Bank 6ITExamAnswers asked 4 years ago • ,
What are two purposes of LISP? (Choose two.)
IT Questions Bank 2IT Administrator asked 2 years ago • 
Which service should be disabled on a router to prevent a malicious host from falsely responding to ARP requests with the intent to redirect the Ethernet frames?
IT Questions Bank 6ITExamAnswers asked 3 years ago • ,
Refer to the exhibit. An ACL was configured on R1 with the intention of denying traffic from subnet 172.16.4.0/24 into subnet 172.16.3.0/24. All other traffic into subnet 172.16.3.0/24 should be permitted. This standard ACL was then applied outbound on interface Fa0/0. Which conclusion can be drawn from this configuration?​
IT Questions Bank 6ITExamAnswers asked 4 years ago • ,
Which two mode combinations would result in the successful negotiation of an EtherChannel? (Choose two.)
IT Questions Bank 6ITExamAnswers asked 3 years ago • ,
Which Cisco security solution uses dynamic content analysis to identify inappropriate content in real time for unknown websites?
IT Questions Bank 2IT Administrator asked 2 years ago • 
What happens to the signal strength of an RF signal due to wave spreading?
IT Questions Bank 2IT Administrator asked 3 years ago • 
« Previous1…4243444546…133Next »
Ask Question