IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPv8 ENARSIWhat must be permitted within an IPv6 ACL for an EIGRPv6 neighbor adjacency to be formed?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich of the following must match to form an EIGRPv6 neighborship? (Choose two.)ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich of these commands can you use to verify which interfaces are participating in the named EIGRP IPv4 address family? (Choose two.)ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich EIGRPv6 command enables you to verify whether a neighboring router is a stub router?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich EIGRPv6 command enables you to verify whether the local router is a stub router?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich EIGRPv6 command is used to verify whether any interfaces have been configured as passive interfaces?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIEnabling EIGRPv6 on an interface with EIGRPv6 named mode configuration requires _____.ITExamAnswers asked 1 year ago • CCNPv8 ENARSIEnabling EIGRPv6 on an interface with EIGRPv6 classic configuration requires _____.ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhat address does the EIGRPv6 hello packet use for the destination address?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIThe IP addressing scheme for your routing domain is discontiguous. What command should you use in EIGRP configuration mode to make sure that you do not have any routing issues in your EIGRP autonomous system?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIAn EIGRP summary route is not showing up on the expected routes in the AS. Which of the following questions should you answer while troubleshooting? (Choose three.)ITExamAnswers asked 1 year ago • CCNPv8 ENARSIYou have a DMVPN network that has a hub and three spokes. The spokes are not learning the routes of the other spokes. Of the following options, which is most likely the reason for this?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich command enables you to verify the maximum paths configured for load balancing and whether unequal-path load balancing has been enabled?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIWhich command enables you to verify whether any route filters have been applied to an EIGRP-enabled interface?ITExamAnswers asked 1 year ago • CCNPv8 ENARSIBesides a neighbor relationship not being formed, which three of the following are reasons routes might be missing in an EIGRP autonomous system? (Choose three.)ITExamAnswers asked 1 year ago • CCNPv8 ENARSI