IT Questions Bank

Mar 16, 2020 Last Updated: Apr 13, 2022 No Comments
Tweet Share Pin it



IT Questions Bank › Category: CCNPv8 ENARSI
In addition to no shutdown , which two commands must a network technician issue on the interface of a Cisco router to enable OSPFv3 address families for IPv6 on that interface? (Choose two.)
ITExamAnswers asked 3 weeks ago • 
Refer to the exhibit. R1 and R2 are connected to the same LAN segment and are configured to run OSPFv3. They are not forming a neighbor adjacency. What is the cause of the problem?
ITExamAnswers asked 2 years ago • ,
Refer to the exhibit. A network administrator has attempted to implement a default route from R1 to the ISP and propagate the default route to EIGRP neighbors. Remote connectivity from the EIGRP neighbor routers to the ISP connected to R1 is failing. Based on the output from the exhibit, what is the most likely cause of the problem?
ITExamAnswers asked 2 years ago • 
An administrator is troubleshooting two routers in an OSPFv3 network. They are trying to establish an OSPFv3 adjacency over an Ethernet link, but the adjacency is not forming. What are two possible reasons for this issue? (Choose two.)
ITExamAnswers asked 3 weeks ago • 
Multiple paths exist in the BGP table. Assuming the weights are the same, what will the next determining factor be?
IT Administrator asked 2 years ago • , ,
Which three statements describe the default operation of route redistribution? (Choose three.)
ITExamAnswers asked 3 weeks ago • 
Refer to the exhibit. A network engineer is troubleshooting a configuration for EIGRP and OSPF mutual redistribution. Why is the OSPF process not receiving all of the redistributed EIGRP routes?
ITExamAnswers asked 3 weeks ago • 
A network engineer has manually configured the hello interval to 15 seconds on an interface of a router that is running OSPFv2. By default, how will the dead interval on the interface be affected?
ITExamAnswers asked 3 years ago • ,
In a mulitarea OSPF internetwork, which route source descriptor is used to denote the best paths within the internetwork that are as a result of processing type 3 and type 4 LSAs?
IT Administrator asked 1 week ago • 
Which of the following techniques is the second selection criterion for the BGP best path?
ITExamAnswers asked 2 weeks ago • ,
Which of the following is not a well-known BGP community?
ITExamAnswers asked 2 weeks ago • ,
True or false: A BGP AS_Path ACL and a prefix list can be applied to a neighbor at the same time.
ITExamAnswers asked 2 weeks ago • ,
What happens to a route that does not match the PrefixRFC1918 prefix list when using the following route map?
ITExamAnswers asked 2 weeks ago • ,
Which network prefixes match the prefix match pattern 10.168.0.0/13 ge 24? (Choose two.)
ITExamAnswers asked 2 weeks ago • ,
True or false: The IPv6 address family must be initialized to establish a BGP session with a peer using IPv6 addressing.
ITExamAnswers asked 2 weeks ago • ,
123…19Next »
Ask Question