IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPv8 ENCORTrue or false: An extended ACL used to match routes changes behavior if the routing protocol is an IGP rather than BGP.ITExamAnswers asked 1 year ago • CCNPv8 ENCORTransit routing between a multihomed enterprise network and a service provider is generally not recommend in which scenarios? (Choose all that apply.)ITExamAnswers asked 1 year ago • CCNPv8 ENCORTrue or false: The IPv6 address family must be initialized to establish a BGP session with a peer using IPv6 addressing.ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORWhich BGP command advertises a summary route to prevent link-flap processing by downstream BGP routers?ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORTrue or false: BGP advertises all its paths for every prefix so that every neighbor can build its own topology table.ITExamAnswers asked 1 year ago • CCNPv8 ENCORHow many tables does BGP use for storing prefixes?ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORWhich command is used to view the BGP neighbors and their hello interval?ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORTrue or false: The IPv4 address family must be initialized to establish a BGP session with a peer using IPv4 addressing.ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORTrue or false: A BGP session is always one hop away from a neighbor.ITExamAnswers asked 1 year ago • CCNPv8 ENCORTrue or false: BGP supports dynamic neighbor discovery by both routers.ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORWhich BGP attribute must be recognized by all BGP implementations and advertised to other autonomous systems?ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORWhich of the following autonomous system(s) are private? (Choose two.)ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORTrue or false: OSPFv3 support for IPv4 networks only requires that an IPv4 address be assigned to the interface and that the OSPFv3 process be initialized for IPv4.ITExamAnswers asked 1 year ago • CCNPv8 ENARSI, CCNPv8 ENCORTrue or false: On a brand-new router installation, OSPFv3 requires only that an IPv6 link-local address be configured and that OSPFv3 be enabled on that interface to form an OSPFv3 neighborship with another router.ITExamAnswers asked 1 year ago • CCNPv8 ENCORHow do you enable OSPFv3 on an interface?ITExamAnswers asked 1 year ago • CCNPv8 ENCOR