IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: Network Addressing and Basic TroubleshootingWhich statement is true about the CSMA/CD access method that is used in Ethernet?ITExamAnswers asked 4 years ago • CCNA, Network Addressing and Basic TroubleshootingMatch each item to the type of topology diagram on which it is typically identified.ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhat characteristic of store-and-forward switching is important when a network supports voice over IP (VoIP)?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhich step in the troubleshooting process describes steps that were taken and repair processes that were performed previously?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhich two access methods can be used for in-band configuration of a Cisco device? (Choose two.)ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingA technician is troubleshooting a network device and suspects there might be a duplex mismatch. What could cause a duplex mismatch?ITExamAnswers asked 4 years ago • Network Addressing and Basic TroubleshootingAn IPv6 host receives a MAC address resolution request. Which message would the host send back in responding to the request?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhat single subnet mask would be appropriate to use for the three subnetworks?ITExamAnswers asked 4 years ago • Network Addressing and Basic TroubleshootingIPv6 host A is sending a neighbor solicitation message to IPv6 host B on the same Ethernet network. What type of address is used in the Destination MAC field of the Ethernet frame header?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhat are three services provided by IPv6 neighbor discovery protocol? (Choose three.)ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingAn IPv6 host needs to send a message to resolve the MAC address of another host, which message would be used to start the process?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingAn IPv6 host needs to start communication with another IPv6 host on the same network. Which message should the sending host send to find the MAC address of the destination host?ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingPlace the ICMPv6 ND messages in correct function category.ITExamAnswers asked 2 years ago • Network Addressing and Basic TroubleshootingWhat are two ICMPv6 messages that are not present in ICMP for IPv4? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOps, Network Addressing and Basic TroubleshootingAn IPv6 enabled device sends a data packet with the destination address of FF02::2. What is the target of this packet?ITExamAnswers asked 4 years ago • Network Addressing and Basic Troubleshooting