IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: Network FundamentalsRefer to the exhibit. Which names correctly identify the CLI mode represented by the prompt for Switch-East4#? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsUsers in the network are experiencing slow response time when doing file transfers to a remote server. What command could be issued to determine if the router has experienced any input or output errors?ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. A network administrator on HostA has problems accessing the FTP server. Layer three connectivity testing was successful from HostA to the S1 interface of RouterB. Which set of commands will allow the network administrator to telnet to RouterB and run debug commands?ITExamAnswers asked 2 years ago • Network FundamentalsWhen network services fail, which port is most often used to access a router for management purposes?ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. A technician applies the configuration in the exhibit to a clean router. To verify the configuration, the technician issues the show running-config command in the CLI session with the router. What lines should the technician expect to see in the router output from the show running-config command?ITExamAnswers asked 2 years ago • Network FundamentalsIn a Cisco router, when do changes made to the running-configuration take effect?ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. What command will place the router into the correct mode to configure an appropriate interface to connect to a LAN?ITExamAnswers asked 2 years ago • Network FundamentalsWhat are three common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. Assume that all devices are using default settings. How many subnets are required to address the topology that is shown?ITExamAnswers asked 2 years ago • Network FundamentalsWhich device is used to create or divide broadcast domains?ITExamAnswers asked 2 years ago • Network FundamentalsWhat are two common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsWhich option identifies the primary interface which would be used for initial configuration of a Cisco router?ITExamAnswers asked 2 years ago • Network FundamentalsWhat type of network cable is used between a terminal and a console port?ITExamAnswers asked 2 years ago • Network FundamentalsWhich subnet mask would be assigned to the network address of 192.168.32.0 to provide 254 useable host addresses per subnetwork?ITExamAnswers asked 4 years ago • Network FundamentalsRefer to the exhibit. A network technician has been allocated the 192.168.1.0/24 private IP address range for use in the network that shown in the exhibit. Which subnet mask would be used to meet the host requirements for segment A of this internetwork?ITExamAnswers asked 2 years ago • Network Fundamentals