IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: Network FundamentalsWhen is a straight-through cable used in a network?ITExamAnswers asked 2 years ago • CCNA 1 v4.0 ENetwork, Network FundamentalsIn the graphic, Host A has reached 50% completion in sending a 1 KB Ethernet frame to Host D when Host B wishes to transmit its own frame to Host C. What must Host B do?ITExamAnswers asked 2 years ago • CCNA 1 v4.0 ENetwork, Network FundamentalsWhat is the primary reason for development of IPv6?ITExamAnswers asked 2 years ago • CCNA 1 v4.0 ENetwork, Network FundamentalsExamine the graphic with current configurations. Host A in the Clerical office failed and was replaced. Although a ping to 127.0.0.1 was successful, the replacement computer cannot access the company network. With proxy ARP disabled on the Fa0/0 interface of the New York router, what is the likely cause of the problem?ITExamAnswers asked 2 years ago • CCNA 1 v4.0 ENetwork, Network FundamentalsWhat are the key factors to consider when grouping hosts into a common network? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 1 v4.0 ENetwork, Network FundamentalsIn an IPv4 environment, what information is used by the router to forward data packets from one interface of a router to another?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsHow many host addresses may be assigned on each subnetwork when using the 130.68.0.0 network address with a subnet mask of 255.255.248.0?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsWhy are port numbers included in the TCP header of a segment?ITExamAnswers asked 4 years ago • CCNA Discovery v4, Network FundamentalsRefer to the exhibit. Host1 is in the process of setting up a TCP session with Host2. Host1 has sent a SYN message to begin session establishment. What happens next?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsRefer to the exhibit. Host A is connected to the LAN, but it cannot get access to any resources on the Internet. The configuration of the host is shown in the exhibit. What could be the cause of the problem?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsWhich three addresses belong to the category of private IP addresses? (Choose three.)ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsWhat does the term “attenuation” mean in data communication?ITExamAnswers asked 4 years ago • CCNA, CCNA Discovery v4, Network FundamentalsWhich of the following are the address ranges of the private IP addresses? (Choose three.)ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsIf the default gateway is configured incorrectly on the host, what is the impact on communications?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOps, CCNA Discovery v4, CCNP, Network Addressing and Basic Troubleshooting, Network Fundamentals, Networking Basics, Networking EssentialsWhat is the purpose of a default gateway?IT Administrator asked 3 years ago • CCNA Discovery v4, DevNet, Network Fundamentals