IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: Network FundamentalsRefer to the exhibit. The network administrator has assigned the internetwork of LBMISS an address range of 192.168.10.0. This address range has been subnetted using a /29 mask. In order to accommodate a new building, the technician has decided to use the fifth subnet for configuring the new network (subnet zero is the first subnet). By company policies, the router interface is always assigned the first usable host address and the workgroup server is given the last usable host address. Which configuration should be entered into the workgroup server’s properties to allow connectivity to the network?ITExamAnswers asked 2 years ago • Network FundamentalsHow many bits make up an IPv4 address?ITExamAnswers asked 2 years ago • Network Fundamentals, Networking BasicsRefer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The network that contains the serial link has already been addressed out of a separate range. Each network will be allocated the same number of host addresses. Which network mask will be appropriate to address the remaining networks?ITExamAnswers asked 2 years ago • Network FundamentalsWhat statement describes the purpose of a default route?ITExamAnswers asked 2 years ago • Network FundamentalsWhat two characteristics are commonly associated with dynamic routing protocols? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. The network in the exhibit is fully operational. What two statements correctly describe the routing for the topology that is shown? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. A network administrator notices that there are too many broadcasts on the network. What two steps can the network administrator take to resolve this problem? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. A network administrator is troubleshooting a connectivity problem and needs to determine the address that is used to forward network packets out the network. Using the netstat -r command, the administrator would identify which address as the address to which all hosts send packets that are destined for an outside network?ITExamAnswers asked 2 years ago • Network FundamentalsWhich three statements are true about routes and their use? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. All devices shown in the exhibit have factory default settings. How many broadcast domains are represented in the topology that is shown?ITExamAnswers asked 2 years ago • Network FundamentalsWhat are three common problems with a large network? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsWhich intermediary devices could be used to implement security between networks? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsWhat is a component of a routing table entry?ITExamAnswers asked 2 years ago • Network FundamentalsWhen the destination network is not listed in the routing table of a Cisco router, what are two possible actions that the router might take? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsWhat type of routing uses information that is manually entered into the routing table?ITExamAnswers asked 2 years ago • Network Fundamentals