A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?

IT Questions Bank › Category: CCNA › A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?

Question:
A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?

show ip interface brief
show ip protocols
show ip route
tracert

Explanation: The network administrator should use the show ip interface brief command to verify that the exit interface or the interface connected to the next hop address is up and up. The show ip route command has already been issued by the administrator. The show ip protocols command is used when a routing protocol is enabled. The tracert command is used from a Windows PC.

Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 2 Exam Answers
Exam with this question: 16.3.4 Module Quiz - Troubleshoot Static and Default Routes Answers