After implementing an IPv6 network, the administrator notices that the OSPFv3 process is not starting on the routers. What could be the problem?
- No router IDs are configured on the routers.
- Authentication was not implemented between the routers.
- The routers were not configured with the network command.
- The routers are configured with the default priority.
Explanation: OSPF does not need to configure any authentication to run. In an IPv6 network, if there are no IPv4 addresses configured on the router, then the router ID must be manually configured with the router-id rid command; otherwise, the OSPFv3 process does not start. OSPFV3 does not use the network command. Instead OSPFv3 is enabled directly on the interface.
Exam with this question: Chapter 10: Quiz - Troubleshooting OSPFv3 CCNPv8 ENARSI
Exam with this question: CCNA 3 Final Exam Answers
Please login or Register to submit your answer