IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it When do directly connected networks appear in the routing table?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich command will show the administrative distance of routes?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingHow many equal cost paths can a dynamic routing protocol use for load balancing by default?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich routing protocol has the most trustworthy administrative distance by default?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich two parameters are used to calculate metrics? (Choose two.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich statement best describes convergence on a network?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingMatch the routing protocol to its description.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat are two advantages of static routing over dynamic routing? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 2 v4.0 ERouting, CCNA 2 v6, CCNA 2 v7Drag the commands on the left to the description of their output on the right.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingDrag the commands on the left to the associated configuration task on the right.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich statement is true concerning directly connected routes?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. Which type of connector is shown in the exhibit?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich of the following is a function of the IOS command show cdp neighbors?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich three are characteristics of a static route? (Choose three.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingObserve the graphic. Which command correctly configures a static default route on R1?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERouting