IT Questions Bank

Mar 16, 2020 Last Updated: Apr 13, 2022 No Comments
Tweet Share Pin it



IT Questions Bank › Category: CCNA 2 v7
What is used in the EUI-64 process to create an IPv6 interface ID on an IPv6 enabled interface?
ITExamAnswers asked 3 years ago • , ,
A network administrator configures a router to send RA messages with M flag as 0 and O flag as 1. Which statement describes the effect of this configuration when a PC tries to configure its IPv6 address?
ITExamAnswers asked 3 years ago • ,
A company uses the SLAAC method to configure IPv6 addresses for the employee workstations. Which address will a client use as its default gateway?
ITExamAnswers asked 3 weeks ago • ,
A host on the 10.10.100.0/24 LAN is not being assigned an IPv4 address by an enterprise DHCP server with the address 10.10.200.10/24. What is the best way for the network engineer to resolve this problem?
ITExamAnswers asked 2 years ago • ,
What is an advantage of configuring a Cisco router as a relay agent?
ITExamAnswers asked 3 years ago • ,
Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server?
ITExamAnswers asked 3 years ago • , , ,
What happens to switch ports after the VLAN to which they are assigned is deleted?
ITExamAnswers asked 3 years ago • , ,
Which two characteristics match extended range VLANs? (Choose two.)
ITExamAnswers asked 3 years ago • ,
Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?
ITExamAnswers asked 3 years ago • , ,
What are two primary benefits of using VLANs? (Choose two.)
ITExamAnswers asked 3 weeks ago • ,
Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port?
ITExamAnswers asked 3 years ago • ,
Which two statements are true regarding switch port security? (Choose two.)
ITExamAnswers asked 3 years ago • , , ,
Which action will bring an error-disabled switch port back to an operational state?
ITExamAnswers asked 3 years ago • , ,
What is one difference between using Telnet or SSH to connect to a network device for management purposes?
ITExamAnswers asked 3 years ago • , , , ,
In which situation would a technician use the show interfaces command?
ITExamAnswers asked 3 weeks ago • ,
123…20Next »
Ask Question