IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it Refer to the exhibit. Routers RTR-1 and RTR-3 are completely configured. The administrator needs to configure the routing protocol on router RTR-2 so that communication occurs throughout the network. Which group of commands will successfully configure EIGRP on RTR-2?ITExamAnswers asked 9 months ago • CCNA Discovery v4Which Layer 4 protocol does EIGRP use to provide reliability for the transmission of routing information?ITExamAnswers asked 9 months ago • CCNA Discovery v4Refer to the exhibit. Which statement is true about the EIGRP authentication configuration?ITExamAnswers asked 9 months ago • CCNA Discovery v4A network administrator issues the command show ip route and sees this line of output: 192.168.3.0/24 [120/2] via 192.168.2.2, 00:00:05, Serial0/0 What two pieces of information can be obtained from the output? (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What is the default administrative distance for EIGRP internal routes?ITExamAnswers asked 9 months ago • CCNA Discovery v4What two problems may occur if the EIGRP default bandwidth for a serial link is higher than the actual bandwidth? (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What is indicated when an EIGRP route is in the passive state?ITExamAnswers asked 4 years ago • CCNA 3 v6, CCNA Discovery v4Given the following commands: What three conclusions can be determined based on the commands used on the router? (Choose three.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What three statements are true about routers that are configured for EIGRP? (Choose three.)ITExamAnswers asked 9 months ago • CCNA Discovery v4When configuring NAT on a Cisco router, what is the inside local IP address?ITExamAnswers asked 9 months ago • CCNA Discovery v4Refer to the exhibit. Which two are valid VLSM network addresses for the serial link between Router1 and Router2? (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4What are the network and broadcast addresses for host 192.168.100.130/27? (Choose two.)ITExamAnswers asked 9 months ago • CCNA Discovery v4How many addresses will be available for dynamic NAT translation when a router is configured with the following commands?ITExamAnswers asked 9 months ago • CCNA Discovery v4Refer to the exhibit. Based on the output of the show ip nat translations command, which kind of address translation is in effect on this router?ITExamAnswers asked 9 months ago • CCNA Discovery v4What range of networks are summarized by the address and mask, 192.168.32.0/19?ITExamAnswers asked 9 months ago • CCNA Discovery v4