Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?

Question:
Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?

• The entire command, configure terminal, must be used.
• The administrator is already in global configuration mode.
• The administrator must first enter privileged EXEC mode before issuing the command.
• The administrator must connect via the console port to access global configuration mode.

Explanation: In order to enter global configuration mode, the command configure terminal, or a shortened version such as config t, must be entered from privileged EXEC mode. In this scenario the administrator is in user EXEC mode, as indicated by the > symbol after the hostname. The administrator would need to use the enable command to move into privileged EXEC mode before entering the configure terminal command.

Exam with this question: Modules 1 – 3: Basic Network Connectivity and Communications Exam Answers
Exam with this question: CCNA 1 v7.0 Final Exam Answers
Exam with this question: CCNA 1 (v5.1 + v6.0) Practice Final Exam Answers
Exam with this question: Introduction to Networks (Version 7.0) – ITNv7 Practice Final Exam
Exam with this question: Networking Essentials (Version 2) – Modules 17 – 20: Introduction to Cisco Networking Pre-Test Exam
Exam with this question: Checkpoint Exam: Configure Cisco Devices Answers
Exam with this question: 18.4.2 Module 18 - The Cisco IOS Command Line Quiz