Refer to the exhibit. During the network upgrade process, a network administrator included switch SW2 in the network. Immediately afterward, the users on VLAN 10 who were connected to SW10 lost connectivity to the network. Based on the show vtp status command outputs that are provided, what could be done to remedy the problem?

Aug 25, 2023 Last Updated: Aug 25, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNP SWITCH v6.0 › Refer to the exhibit. During the network upgrade process, a network administrator included switch SW2 in the network. Immediately afterward, the users on VLAN 10 who were connected to SW10 lost connectivity to the network. Based on the show vtp status command outputs that are provided, what could be done to remedy the problem?

Refer to the exhibit. During the network upgrade process, a network administrator included switch SW2 in the network. Immediately afterward, the users on VLAN 10 who were connected to SW10 lost connectivity to the network. Based on the show vtp status command outputs that are provided, what could be done to remedy the problem?

  • Configure switch SW2 in VTP client mode.
  • Configure switch SW2 with VTP version 1.
  • Configure switch SW2 with the higher revision number.
  • Configure switch SW2 with the same VTP domain name that SW1 has.

Exam with this question: CCNP SWITCH (Version 6.0) Chapter 2 Exam

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments