Refer to the exhibit. The NAT configuration applied to the router is as follows: Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

IT Questions Bank › Refer to the exhibit. The NAT configuration applied to the router is as follows: Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

Question:
Refer to the exhibit. The NAT configuration applied to the router is as follows:

ERtr(config)# access-list 1 permit 10.0.0.0 0.255.255.255
ERtr(config)# ip nat pool corp 209.165.201.6 209.165.201.30 netmask 255.255.255.224
ERtr(config)# ip nat inside source list 1 pool corp overload
ERtr(config)# ip nat inside source static 10.10.10.55 209.165.201.4
ERtr(config)# interface gigabitethernet 0/0
ERtr(config-if)# ip nat inside
ERtr(config-if)# interface serial 0/0/0
ERtr(config-if)# ip nat outside

Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

Static NAT is working, but dynamic NAT is not.
Dynamic NAT is working, but static NAT is not.
Not enough information is given to determine if both static and dynamic NAT are working.
NAT is working.

Explanation: There is not enough information given because the router might not be attached to the network yet, the interfaces might not have IP addresses assigned yet, or the command could have been issued in the middle of the night. The output does match the given configuration, so no typographical errors were made when the NAT commands were entered.

Exam with this question: Modules 6 – 8: WAN Concepts Exam Answers