Refer to the exhibit. The network administrator correctly configures RTA to perform inter-VLAN routing. The administrator connects RTA to port 0/4 on SW2, but inter-VLAN routing does not work. What could be the possible cause of the problem with the SW2 configuration?

Dec 1, 2022 Last Updated: Dec 1, 2022 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA 3 v4 › Refer to the exhibit. The network administrator correctly configures RTA to perform inter-VLAN routing. The administrator connects RTA to port 0/4 on SW2, but inter-VLAN routing does not work. What could be the possible cause of the problem with the SW2 configuration?

Refer to the exhibit. The network administrator correctly configures RTA to perform inter-VLAN routing. The administrator connects RTA to port 0/4 on SW2, but inter-VLAN routing does not work. What could be the possible cause of the problem with the SW2 configuration?

  • Port 0/4 is not active.
  • Port 0/4 is not a member of VLAN1.
  • Port 0/4 is configured in access mode.
  • Port 0/4 is using the wrong trunking protocol.

Exam with this question: CCNA Exploration 3: ESwitching Chapter 6 Exam

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments
0
Would love your thoughts, please comment.x
()
x