Switch SW1 needs to be configured to use Dynamic ARP Inspection along with DHCP Snooping in VLAN 6 and only VLAN 6. Which commands must be included, assuming at least one switch port in VLAN 6 must be a trusted port? (Choose two answers.)

IT Questions BankCategory: CCNASwitch SW1 needs to be configured to use Dynamic ARP Inspection along with DHCP Snooping in VLAN 6 and only VLAN 6. Which commands must be included, assuming at least one switch port in VLAN 6 must be a trusted port? (Choose two answers.)

Switch SW1 needs to be configured to use Dynamic ARP Inspection along with DHCP Snooping in VLAN 6 and only VLAN 6. Which commands must be included, assuming at least one switch port in VLAN 6 must be a trusted port? (Choose two answers.)

  • no ip arp inspection untrust
  • ip arp inspection trust
  • ip arp inspection
  • ip arp inspection vlan 6

Explanation: Because of a default setting of untrusted, the switch must be configured so DAI trusts that one port. To add that configuration, the switch needs the ip arp inspection trust command in interface config mode. The similar (incorrect) answer of no ip arp inspection untrust is not a valid command.
To enable DAI for operation on a VLAN, the configuration needs one command: the ip arp inspection vlan 6 command. This command both enables DAI and does so specifically for VLAN 6 alone. The answer ip arp inspection shows a command that would be rejected by the switch as needing more parameters.

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments