Two OSPFv2 routers are interconnected using a point-to-point WAN link.Which command could be used to verify the configured Hello and Dead timer intervals?

IT Questions BankCategory: CCNA 3 v7Two OSPFv2 routers are interconnected using a point-to-point WAN link.Which command could be used to verify the configured Hello and Dead timer intervals?

Two OSPFv2 routers are interconnected using a point-to-point WAN link.Which command could be used to verify the configured Hello and Dead timer intervals?

  • show ip ospf neighbor
  • show ip ospf interface fastethernet 0/1
  • show ip ospf interface serial 0/0/0
  • show ipv6 ospf interface serial 0/0/0

Explanation: The show ip ospf interface serial 0/0/0 command displays the configured Hello and Dead timer intervals on a point-to-point serial WAN link between two OSPFv2 routers. The show ipv6 ospf interface serial 0/0/0 command displays the configured Hello and Dead timer intervals on a point-to-point serial link between two OSPFv3 routers. The show ip ospf interface fastethernet 0/1 command displays the configured Hello and Dead timer intervals on a multiaccess link between two (or more) OSPFv2 routers. The show ip ospf neighbor command displays the Dead interval elapsed time since the last Hello message was received, but it does not show the configured value of the timer.

Exam with this question: 2.7.5 Module Quiz - Single-Area OSPFv2 Configuration

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments