IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 1 v4.0 ENetwork
Which utility shows the route a packet takes to reach its destination?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What does it mean when the ping command returns a result of “.”?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
A network administrator must configure a serial interface with an IP address. The configuration must also identify the remote site to which the interface is connected. Which set of commands will meet these requirements?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
An administrator configures a new router and names it SANJOSE. The administrator needs to set a password that will be required to establish a console session with the router. What commands should be issued by the administrator to set the console password to CISCO?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What command will display a list of commands available for viewing the status of the router?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which command will display statistics for all interfaces configured on a router?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What is the purpose of the IOS enable secret command?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which command turns on a router interface?
IT Questions Bank 2ITExamAnswers asked 11 months ago • ,
Which command sequence will permit access to five virtual terminal lines with a password of cisco?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
A copy of a configuration file can be saved to a TFTP server. Construct the command sequence to accomplish this task. (Not all options apply.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
What primary factor should be addressed before using wireless technology?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Which UTP cable lengths are specified by ANSI/TIA/EIA-568-B standards? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Refer to the exhibit. Which option defines the default port configuration settings used to establish this direct serial connection between a computer and a Cisco networking device?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Refer to the exhibit. What type of cable connects the two routers together without any intermediary device?
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
Match the “Slash format” number with the mask number to subnet the last octet.
IT Questions Bank 2ITExamAnswers asked 7 months ago • 
123…7Next »
Ask Question