A network administrator must configure a serial interface with an IP address. The configuration must also identify the remote site to which the interface is connected. Which set of commands will meet these requirements?

IT Questions Bank › Category: CCNA 1 v4.0 ENetwork › A network administrator must configure a serial interface with an IP address. The configuration must also identify the remote site to which the interface is connected. Which set of commands will meet these requirements?

Chicago(config)# description San Jose T1
Chicago(config)# interface serial0/0
Chicago(config-if)# ip address 192.168.204.9 255.255.255.252
Chicago(config)# interface serial0/0
Chicago(config-if)# ip address 192.168.204.9 255.255.255.252
Chicago(config-if)# description San Jose T1
Chicago(config)# interface serial0/0
Chicago(config-if)# ip address 192.168.204.9 netmask 255.255.255.252
Chicago(config-if)# description San Jose T1
Chicago(config)# interface serial0/0
Chicago(config-if)# ip address 192.168.204.9 255.255.255.252
Chicago(config-if)# remote site San Jose T1
Chicago(config)# interface serial0/0
Chicago(config-if)# ip address 192.168.204.9 255.255.255.252
Chicago(config-if)# interface description San Jose T1

Exam with this question: CCNA 1 Exploration v4.0 Chapter 11 Quiz