IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4.0 ERoutingRefer to the exhibit. Router C is running version 12.3 of the IOS. The router receives a packet with a destination of 172.16.1.130. Which route will router C use to forward the packet?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRouter R1 is configured with R1(config)# no ip classless and R1(config)# ip route 0.0.0.0 0.0.0.0 s0/0/0. What will R1 do with a packet that matches a parent route but does not match any associated child routes?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat do the ip classless and no ip classless commands do?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingIf a packet matches a level 1 parent route in the routing table, what occurs next in the lookup process?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingIn the route lookup process, what constitutes the preferred route?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat action will enable classful routing behavior on a router?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRouter R1 is configured with R1(config)# ip classless and R1(config)# ip route 0.0.0.0 0.0.0.0 s0/0/0. What will R1 do with a packet that matches a parent route but does not match any associated child routes?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. Which two routes are considered parent routes? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich characteristic can be used to determine if a route is an ultimate route?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. What three types of routes are displayed in this routing table? (Choose three).ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. What can be determined from this output?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. If all routers are running RIP version 2, why is there no route for the 192.168.1.32/27 network?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERoutingRefer to the exhibit. The exhibit shows partial results from the debug ip rip events command on router B. What is the likely cause of the debug messages?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingHow do RIP v1 and RIP v2 differ?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat condition would RIPv2 allow that RIPv1 would not allow?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERouting