IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4.0 ERoutingWhat is the default behavior of the RIP routing protocol if no version type is specified?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich statement regarding RIPv2 is correct?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat two commands will determine whether auto-summarization is in effect for RIP? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. The network administrator wants to minimize the number of entries in Router1’s routing table. What should the administrator implement on the network?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERoutingCategorize each address by placing it in the appropriate group. Not all items are used.ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingHow many bits are used in the IPv4 address space?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. A network engineer is summarizing the two groups of routes on router R1 shown in the exhibit. Which summarization will work for all the subnets?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERoutingSelect the VLSM subnets of the 172.16.0.0 network that will simultaneously provide the total number of required hosts on each subnet? Match the subnet with the number of required hosts by dragging the options on the left to the targets on the right. Not all options are used.ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhen using a classful class A IP address scheme, how many octects are used to designate the network portion of the address?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich of the following identify the most efficient use for each of these masks? (Choose three.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat two methods were used to allow the continued use of IPv4 addressing once the available hosts were exhausted? (Choose two).ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingDrag the description on the left to the appropriate term on the right. (Not all options are used.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingDivide the items on the left into the targets on the right determining support for VLSM.ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingTo ensure proper routing in a network, the network administrator should always check the router configuration to verify that appropriate routes are available. The commands on the left will allow the network administrator to view the router configuration for the information needed. Drag each command to its result.ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat is the purpose of the network command when RIP is being configured as the routing protocol?ITExamAnswers asked 7 months ago • CCNA 2 v4.0 ERouting, CCNA Discovery v4