IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4RIPv2 is the configured routing protocol on the routers in a network. The command Router(config-router)# no version 2 is entered on the routers. What effect does entering this command have on routing updates?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technician enters the following set of commands on the router: Why does the router respond with an error?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which two statements are true? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on each router: When this configuration is complete, users on the LAN of each router are unable to access the remote LANs. Why?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What effect will the commands that are shown have on RIP updates for Router1?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are running RIPv1. What changes will occur in the routing table of router B if a loopback interface with an address of 10.16.1.129/27 is configured on router B?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What can be concluded from the output shown in the exhibit?ITExamAnswers asked 2 years ago • CCNA 2 v4What field was added to the RIP message header by RFC 1723 to add support for VLSM and CIDR?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What subnet mask will be applied by router B when it receives a RIPv1 update for the network 172.16.1.0?ITExamAnswers asked 2 years ago • CCNA 2 v4A router has a summary route to network 192.168.32.0/20 installed in its routing table. What range of networks are summarized by this route?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator needs to create two subnetworks from 10.0.0.0/8 for a router running RIPv2. The Admin subnet requires 120 hosts and the Sales subnet requires 58 hosts. The network administrator assigned 10.0.1.128/25 to the Admin subnet. The Sales subnet is given 10.0.1.192/26. What will be the result of this addressing scheme?ITExamAnswers asked 2 years ago • CCNA 2 v4What is a supernet?ITExamAnswers asked 2 years ago • CCNA 2 v4An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following subnet addresses can be configured in this network to provide a maximum of 14 useable addresses for this link while wasting the fewest addresses?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The number of required host addresses for each subnet in a network is listed in the exhibit. This number includes the host address requirements for all router ports and hosts on that subnet. After all device and router port address assignments are determined, what will be the total number of unused host addresses available?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What subnet mask will be applied if Router A sends a RIPv1 update for the network 172.16.1.0 to Router B?ITExamAnswers asked 2 years ago • CCNA 2 v4