Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technician enters the following set of commands on the router: Why does the router respond with an error?

IT Questions BankCategory: CCNA 2 v4Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technician enters the following set of commands on the router: Why does the router respond with an error?

Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technician enters the following set of commands on the router:

Sanford(config)# interface loopback1
Sanford(config-if)# ip address 192.168.6.62 255.255.255.252

Why does the router respond with an error?

  • The router does not allow loopback interface configurations.
  • This mask can not be used with this class of addresses.
  • Classless routing must be configured before this address can be added.
  • The network address for Loopback1 overlaps with an already configured interface address.
  • The router is over the limit for the maximum paths that can be provided in the routing table.

Exam with this question: CCNA Exploration 2: ERouting Chapter 7 Exam Answers

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments