IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4The graphic shows a network that is configured to use RIP routing protocol. Router2 detects that the link to Router1 has gone down. It then advertises the network for this link with a hop count metric of 16. Which routing loop prevention mechanism is in effect?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The routers in this network are running RIP. Router A has not received an update from Router B in over three minutes. How will Router A respond?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following methods does split horizon use to reduce incorrect routing information?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. If all routers are using RIP, how many rounds of updates will occur before all routers know all networks?ITExamAnswers asked 2 years ago • CCNA 2 v4What does a router running RIP do first with a new route that is received from an advertisement?ITExamAnswers asked 2 years ago • CCNA 2 v4What actions will occur after RouterA loses connectivity to network 114.125.16.0? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4When multiple routing protocols have a route to the same destination network, what determines which route is installed in the routing table?IT Administrator asked 3 years ago • CCNA 2 v4, CCNPA router learns two paths with equal metrics to a destination network via the RIP routing protocol. How will the router handle packets to the destination network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. If RIP is the routing protocol, what is the value of the metric from router A to network 192.168.5.0/24?ITExamAnswers asked 2 years ago • CCNA 2 v4A growing medium-sized manufacturing company recently began to have routing instability issues. The company uses static routes and has a mixture of over 30 Cisco and non-Cisco routers. The network administrator has decided to convert the network to dynamic routing. What characteristics of protocols should be considered in this selection process?ITExamAnswers asked 2 years ago • CCNA 2 v4The following line of code is present in the routing table: O 10.16.1.0/27 [110/129] via 192.168.1.5, 00:00:05, Serial0/0/1 What does the number 129 indicate in this output?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Router1 and Router2 are running EIGRP. All interfaces are operational and packets can be forwarded between all networks. What information will be found in the routing table for Router1?ITExamAnswers asked 2 years ago • CCNA 2 v4An engineer creates a static route by entering the Router(config)# ip route 10.0.0.0 255.255.255.0 192.168.1.2 command. What can be concluded about this route?ITExamAnswers asked 2 years ago • CCNA 2 v4What will be the result of the following commands? ORL(config)# interface fastethernet 0/0 ORL(config-if)# ip address 172.16.3.1 255.255.255.0 ORL(config-if)# no shutdownITExamAnswers asked 2 years ago • CCNA 2 v4The following line of code is displayed in a routing table: R 209.165.201.0/24 [120/2] via 192.168.252.2, 00:00:16, S0/0/0 What can be concluded from this output?ITExamAnswers asked 2 years ago • CCNA 2 v4