IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v6What can a network administrator do to access a router if the password has been lost?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7The command ntp server 10.1.1.1 is issued on router R1. What impact does this command have?ITExamAnswers asked 2 years ago • CCNA 2 v6A network administrator has issued the logging trap 4 global configuration mode command. What is the result of this command?ITExamAnswers asked 4 years ago • CCNA 2 v6Which destination do Cisco routers and switches use by default when sending syslog messages for all severity levels?ITExamAnswers asked 4 years ago • CCNA 2 v6Which syslog message type is accessible only to an administrator via the Cisco CLI?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7Which protocol or service allows network administrators to receive system messages that are provided by network devices?ITExamAnswers asked 4 years ago • CCNP, CCNA 2 v6, CCNA 3 v7When logging is used, which severity level indicates that a device is unusable?ITExamAnswers asked 2 years ago • CCNA 2 v6What are the most common syslog messages?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7Which option correctly enables LLDP on an interface?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7What is the configuration command to globally enable LLDP on a Cisco Catalyst switch?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7What information can be gathered about a neighbor device from the show cdp neighbors detail command that cannot be found with the show cdp neighbors command?IT Administrator asked 3 years ago • CCNA, CCNA 2 v6A network administrator wants to configure a router so that only a specific interface will send and receive CDP information. Which two configuration steps accomplish this? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 3 v7What is a difference between CDP and LLDP?ITExamAnswers asked 2 years ago • CCNA 2 v6What is the group of public IPv4 addresses used on a NAT-enabled router known as?ITExamAnswers asked 2 years ago • CCNA 2 v6What are two of the required steps to configure PAT? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 2 v6, CCNA 3 v7