IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v7Which command is not configured in stateless DHCPv6?ITExamAnswers asked 2 years ago • CCNA 2 v7Which three DHCPv6 roles can a router perform? (Choose all that apply.)ITExamAnswers asked 2 years ago • CCNA 2 v7What M flag setting indicates that stateful DHCPv6 is used?ITExamAnswers asked 2 years ago • CCNA 2 v7What flag settings combination is used for stateless DHCP?ITExamAnswers asked 2 years ago • CCNA 2 v7What DHCPv6 message does a host send to the DHCPv6 server if it is using stateful DHCPv6?ITExamAnswers asked 2 years ago • CCNA 2 v7What DHCPv6 message does a host send to look for a DHCPv6 server?ITExamAnswers asked 2 years ago • CCNA 2 v7What destination UDP port do DHCPv6 clients use to send DHCPv6 messages?ITExamAnswers asked 2 years ago • CCNA 2 v7What method is used by a host to verify an IPv6 address is unique on the local network before assigning that address to an interface?ITExamAnswers asked 2 years ago • CCNA 2 v7Which ICMPv6 message is sent by a host in an attempt to locate an online IPv6enabled router to obtain IPv6 addressing information?ITExamAnswers asked 2 years ago • CCNA 2 v7What are the flag settings when a host should use the SLAAC only option?ITExamAnswers asked 2 years ago • CCNA 2 v7Which command must be configured on a router to enable it to join the IPv6 all-routers multicast address ff02::2?ITExamAnswers asked 2 years ago • CCNA 2 v7Which two ICMPv6 messages are used in the SLAAC process? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7Which method best describes stateless DHCP?ITExamAnswers asked 2 years ago • CCNA 2 v7Which address type is automatically created by default on a host interface when no RAs are received?ITExamAnswers asked 2 years ago • CCNA 2 v7Which two DHCPv4 messages are used in the lease renewal process? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7