IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 2 v7
The port closest to the root bridge in terms of least overall cost (best path) to the root bridge is the:
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
The root bridge will be the switch with the:
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
By default (without any configuration on a switch), what will determine which switch is the root bridge?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What device is elected by the Spanning Tree Algorithm? All other switches determine a single least-cost path to this device.
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Without STP on the Ethernet LAN, which three types of frames could cause a catastrophic loop in the network? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Which statement describes STP?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
You are troubleshooting an inter-VLAN issue on a router and need to verify the status and IP address of all interfaces in a condensed format. Which inter-VLAN routing troubleshooting command would you use to do this?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
You are troubleshooting an inter-VLAN issue on a switch and need to verify the status of an access port and its access mode VLAN. Which troubleshooting command would you use to do this?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
You are troubleshooting an inter-VLAN issue on a switch and need to check the list of VLANs and their assigned ports. Which inter-VLAN routing troubleshooting command would you use to do this?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
You are troubleshooting an inter-VLAN issue on a switch and need to verify that the subinterfaces are in the routing table. Which inter-VLAN routing troubleshooting command would you use to do this?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to each of the scenario topologies. Which statements best describe the different types of inter-VLAN routing solutions? (Choose all that apply.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which two DTP modes will form a trunk with an interface that is configured as dynamic auto? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
True or false? Two switchports on a link both configured as dynamic auto will successfully negotiate a trunk.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is the default switchport mode for Cisco Catalyst switches?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
True or false? DTP is an open standard IEEE protocol that specifies auto negotiation of switch trunk links.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…1718192021Next »
Ask Question