IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v6Which command can be used to verify the contents of the LSDB in an OSPF area?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNA 3 v7, CCNPWhat routing table descriptor is used to identify OSPF summary networks that originate from an ABR?ITExamAnswers asked 4 years ago • CCNA 3 v6What type of OSPF LSA is originated by ASBRs to advertise external routes?ITExamAnswers asked 1 year ago • CCNA 3 v6What OSPF LSA type is used to inform routers of the router ID of the DR in each multiaccess network in an OSPF area?ITExamAnswers asked 4 years ago • CCNA 3 v6Which two statements correctly describe OSPF type 3 LSAs? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich of the following is used to facilitate hierarchical scaling in OSPF?ITExamAnswers asked 1 year ago • CCNA 3 v6Which characteristic describes both ABRs and ASBRs that are implemented in a multiarea OSPF network?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat is one advantage of using multiarea OSPF?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which statement describes a multiarea OSPF network?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNA 3 v7Which command will provide information specific to OSPFv3 routes in the routing table?ITExamAnswers asked 4 years ago • CCNA 3 v6Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPSingle area OSPFv3 has been enabled on a router via the ipv6 router ospf 20 command. Which command will enable this OSPFv3 process on an interface of that router?ITExamAnswers asked 4 years ago • CCNA 3 v6A network administrator enters the command ipv6 router ospf 64 in global configuration mode. What is the result of this command?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat does a Cisco router use automatically to create link-local addresses on serial interfaces when OSPFv3 is implemented?ITExamAnswers asked 4 years ago • CCNA 3 v6Which three addresses could be used as the destination address for OSPFv3 messages? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNP