IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v6When will a router that is running EIGRP put a destination network in the active state?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhich command can be issued on a router to verify that automatic summarization is enabled?ITExamAnswers asked 4 years ago • CCNA 3 v6In which scenario will the use of EIGRP automatic summarization cause inconsistent routing in a network?ITExamAnswers asked 4 years ago • CCNA 3 v6Which EIGRP parameter must match between all routers forming an EIGRP adjacency?ITExamAnswers asked 4 years ago • CCNA 3 v6By default, how many equal-cost routes to the same destination network will EIGRP install in the routing table?ITExamAnswers asked 4 years ago • CCNA 3 v6Which command would limit the amount of bandwidth that is used by EIGRP for protocol control traffic to approximately 128 Kbps on a 1.544 Mbps link?ITExamAnswers asked 1 year ago • CCNA 3 v6Which administrative distance is used to advertise routes learned from other protocols that are redistributed into EIGRP?ITExamAnswers asked 4 years ago • CCNA 3 v6What is the purpose of a Null0 route in the routing table?ITExamAnswers asked 4 years ago • CCNA 3 v6Which configuration is necessary to ensure successful operation of EIGRP for IPv6?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPWhat is the multicast address used by an EIGRP-enabled router operating with IPv6?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6A new network administrator has been asked to verify the metrics that are used by EIGRP on a Cisco device. Which two EIGRP metrics are measured by using static values on a Cisco device? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v6Which command is used to display the bandwidth of an interface on an EIGRP-enabled router?ITExamAnswers asked 4 years ago • CCNA 3 v6Which table does EIGRP use to store all routes that are learned from EIGRP neighbors?ITExamAnswers asked 1 year ago • CCNA 3 v6What information does EIGRP maintain within the routing table?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Why would a network administrator use a wildcard mask in the network command when configuring a router to use EIGRP?ITExamAnswers asked 4 years ago • CCNA 3 v6