IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 4 v4Refer to the exhibit. When creating an extended ACL to deny traffic from the 192.168.30.0 network destined for the Web server 209.165.201.30, where is the best location for applying the ACL?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4What is true regarding the differences between NAT and PAT?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which two options can LCP negotiate? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4At what physical location does the responsibilty for a WAN connection change from the user to the service provider?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4What best describes the use of a data-link connection identifier (DLCI)?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which three statements are true regarding LCP? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4How many bits of an IPv6 address are used to identify the interface ID?ITExamAnswers asked 2 years ago • CCNA 4 v4, Network Addressing and Basic TroubleshootingWhich two statements are true regarding the following extended ACL? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Refer to the exhibit. The network administrator creates a standard access control list to prohibit traffic from the 192.168.1.0/24 network from reaching the 192.168.2.0/24 network while still permitting Internet access for all networks. On which router interface and in which direction should it be applied?ITExamAnswers asked 1 year ago • CCNA 4 v4, CCNA Discovery v4Which two statements are correct about extended ACLs? (Choose two)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v5, CCNA 4 v4After activating IPv6 routing on a Cisco router and programming IPv6 addresses on multiple interfaces, what is the remaining step to activate RIPng?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNP ROUTE v6.0Which two functions are provided by the Local Management Interface (LMI) that is used in Frame Relay networks? (Choose two.)ITExamAnswers asked 1 year ago • CCNA 4 v4What are the symptoms when the s0/0/0 interface on a router is attached to an operational CSU/DSU that is generating a clock signal, but the far end router on the point-to-point link has not been activated?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. This router is being configured to use SDM, but the SDM interface of the router cannot be accessed. What is the cause of the problem?ITExamAnswers asked 1 year ago • CCNA 4 v4Refer to the exhibit. Branch A has a Cisco router and Branch B has a non-Cisco router that is using IETF encapsulation . After the commands that are shown are entered, R2 and R3 fail to establish the PVC. The R2 LMI is Cisco, and the R3 LMI is ANSI. The LMI is successfully established at both locations. Why is the PVC failing?ITExamAnswers asked 1 year ago • CCNA 4 v4