IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 4 v4Refer to the exhibit. Which configuration command would result in the output in the exhibit?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which data transmission technology is being represented?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. A network administrator is attempting to configure a Frame Relay network. The administrator enters the commands as shown in the exhibit on R2, but the Frame Relay PVCs are inactive. What is the problem?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. A network administrator is considering updating the IOS on Router1. What version of IOS is currently installed on Router1?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which statement correctly describes how Router1 processes an FTP request packet that enters interface S0/0/0, and is destined for an FTP server at IP address 172.16.1.5?ITExamAnswers asked 2 years ago • CCNA 4 v4What is the result when the command permit tcp 10.25.132.0 0.0.0.255 any eq smtpis added to a named access control list and applied on the inbound interface of a router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. RIPv2 has been configured on all routers in the network. Routers R1 and R3 have not received any RIP routing updates. What will fix the issue?ITExamAnswers asked 2 years ago • CCNA 4 v4While configuring a router using RIPng and dual-stack technology with IPv4 and IPv6, the administrator receives an error message when inputting IPv4 routes. What could cause the error message?ITExamAnswers asked 2 years ago • CCNA 4 v4An issue of response time has recently arisen on an application server. The new release of a software package has also been installed on the server. The configuration of the network has changed recently. To identify the problem, individuals from both teams responsible for the recent changes begin to investigate the source of the problem. Which statement applies to this situation?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which VLAN will carry untagged traffic on FastEthernet 0/1?ITExamAnswers asked 2 years ago • CCNA 4 v4When NAT is in use, what is used to determine the addresses that can be translated on a Cisco router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. From the output of the show interfaces and ping commands, at which layer of the OSI model is a fault indicated?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. The corporate network that is shown has been assigned network 172.16.128.0/19 for use at branch office LANs. If VLSM is used, what mask should be used for addressing hosts at Branch4 with minimal waste from unused addresses?ITExamAnswers asked 2 years ago • CCNA 4 v4A light manufacturing company wishes to replace its DSL service with a non-line-of-sight broadband wireless solution that offers comparable speeds. Which solution should the customer choose?ITExamAnswers asked 2 years ago • CCNA 4 v4Which two protocols in combination should be used to establish a link with secure authentication between a Cisco and a non-Cisco router? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4