IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 4 v4A company uses a PVC with a committed information rate (CIR) of 128 kb/s and a committed burst information rate (CBIR) of 64 kb/s. The link is used to periodically send updates at a rate of 144 kb/s. What will happen to the update traffic?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Why are the routers unable to establish a PPP session?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. The hosts in network A all have static addresses that are assigned in the 192.168.2.0./24 network. The hosts in network B are DHCP clients in the 192.168.1.0/24 network. After router R1 has been configured with the statements as shown in the exhibit, the DHCP clients are reporting that they cannot access any network resources. The hosts with static addresses cannot access any resources outside network A. What is the problem?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. An administrator has added the exhibited commands to routers A and B, but no routing updates are exchanged between the two routers. Based on the information that is given, what is the likely cause of the problem?ITExamAnswers asked 2 years ago • CCNA 4 v4When configuring remote access to a router, what is the significance of the no password command on a VTY line?ITExamAnswers asked 2 years ago • CCNA 4 v4What three statements describe the roles of devices in a WAN? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. This serial interface is not functioning correctly. Based on the output shown, what is the most likely cause?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What is placed in the address field in the header of a frame that will travel from the DC office of ABC Company to the Orlando office?ITExamAnswers asked 2 years ago • CCNA 4 v4What functionality do access control lists provide when implementing dynamic NAT on a Cisco router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. An ACL called Managers already exists on this router. What happens if the network administrator issues the commands as shown in the exhibit?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. PAT has been implemented on router R2. PC1 and PC2 are unsuccessful when attempting to connect to Internet resources. What is a possible cause?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. From the output of the show interface commands, at which OSI layer is a fault indicated?ITExamAnswers asked 2 years ago • CCNA 4 v4A company is looking for a WAN solution to connect its headquarters site with four remote sites. What advantage would dedicated leased lines provide to the customer compared to a shared Frame Relay solution?ITExamAnswers asked 2 years ago • CCNA 4 v4During the initial configuration of a router, the administrator enters the command no service config. How will the router behave as a result of this command?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Routers R1 and R2 have been configured with EIGRP in the same autonomous system. Computers PC1 and PC2 are not able to ping each other. Further investigation has revealed that the route to 192.168.10.0 is missing from the routing table on R2. What is the cause of the problem?ITExamAnswers asked 2 years ago • CCNA 4 v4