IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Refer to the exhibit. The network administrator needs to configure the Fa0/0 interface of RTB so that hosts from RTA can connect to the server that is attached to RTB. Which two commands will the administrator use to accomplish this task? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4The command copy tftp running-config has been entered on the router. What will this command do?ITExamAnswers asked 7 months ago • CCNA Discovery v4A small tire retailer requires a low-cost WAN connection to its headquarters in order to manage its inventory and process customer sales in real time. Which WAN connection type is best suited to its needs?ITExamAnswers asked 7 months ago • CCNA Discovery v4In an IPv4 environment, what information is used by the router to forward data packets from one interface of a router to another?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsHow many host addresses may be assigned on each subnetwork when using the 130.68.0.0 network address with a subnet mask of 255.255.248.0?ITExamAnswers asked 2 years ago • CCNA Discovery v4, Network FundamentalsA hacker attempts to reach confidential information that is stored on a server inside the corporate network. A network security solution inspects the entire packet, determines that it is a threat, and blocks the packet from entering the inside network. Which security measure protected the network?ITExamAnswers asked 7 months ago • CCNA Discovery v4What are two purposes of DNS? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4A network technician is using a network management station to gather data about the performance of devices and links within the ISP. Which application layer protocol makes this possible?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator uses the command below to configure a default route to the ISP network : RTB(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.6 A ping issued from the ISP is successful to router RTB. However, ping echo request packets arrive at a host that is attached to the Fa0/0 interface of RTB, and the replies do not make it back to the ISP router. What will fix this problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The graphic shows the output of a command issued on router RTB. According to the output, what two statements are true of router RTB? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4What is true regarding the differences between NAT and PAT?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which two protocols allow network devices to report their status and events to a centralized network management device? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Given the network 192.168.25.0 shown in the graphic, which subnet mask would accommodate the number of hosts in each subnet?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Which IP addresses could be assigned to the hosts in the diagram? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4What is used by a routing protocol to determine the best path to include in the routing table?ITExamAnswers asked 7 months ago • CCNA Discovery v4