IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAA network administrator is designing an IPv4 addressing scheme and requires these subnets. Which combination of subnets and masks will provide the best addressing plan for these requirements?ITExamAnswers asked 4 years ago • CCNAAn administrator wants to replace the configuration file on a Cisco router by loading a new configuration file from a TFTP server. What two things does the administrator need to know before performing this task? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhat effect does the default-information originate command have on a Cisco router that is configured for RIP?IT Administrator asked 3 years ago • CCNARefer to the exhibit. What would happen after the IT administrator enters the new static route?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Static NAT is being configured to allow PC 1 access to the web server on the internal network. What two addresses are needed in place of A and B to complete the static NAT configuration? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhat type of installation is needed to view syslog messages?IT Administrator asked 3 years ago • CCNAWhat is the purpose of the overload keyword in the ip nat inside source list 1 pool NAT_POOL overload command?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator needs to add an ACE to the TRAFFIC-CONTROL ACL that will deny IP traffic from the subnet 172.23.16.0/20. Which ACE will meet this requirement?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator is reviewing port and VLAN assignments on switch S2 and notices that interfaces Gi0/1 and Gi0/2 are not included in the output. Why would the interfaces be missing from the output?ITExamAnswers asked 4 years ago • CCNAWhat information can be verified through the show ip dhcp binding command?ITExamAnswers asked 4 years ago • CCNAWhat type of traffic is described as not resilient to loss?ITExamAnswers asked 4 years ago • CCNAWhich device tracks the state of active connections in order to make a decision to forward a packet through?IT Administrator asked 3 years ago • CCNARefer to the exhibit. The ntp server 192.168.0.3 command has been configured on router 1 to make it an NTP client of router 2. Which command must be configured on router 2 so that it operates in server-only mode and relies only on its internal clock?IT Administrator asked 3 years ago • CCNAWhich technology must be implemented to configure network device monitoring with the highest security?IT Administrator asked 4 years ago • CCNAHow is the native VLAN secured in a network?IT Administrator asked 3 years ago • CCNA