IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Refer to the exhibit. A network administrator issues the show lldp neighbors command to display information about neighboring devices. What can be determined based on the information?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What is defined by the ip nat pool command when configuring dynamic NAT?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Which address type is not supported by IPv6
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which ACE would permit traffic from hosts only on the 192.168.8.0/22 subnet?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Which two issues might cause excessive runt and giant frames in an Ethernet network? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Which static route would an IT technician enter to create a backup route to the 172.16.1.0 network that is only used if the primary RIP learned route fails?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Which three events will occur as a result of the configuration shown on R1? (Choose three.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network technician is configuring port security on a LAN switch interface. The security policy requires host MAC addresses to be learned dynamically, stored in the address table, and saved to the switch running configuration. Which command does the technician need to add to the following configuration to implement this policy?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network administrator is using the router-on-a-stick model to configure a switch and a router for inter-VLAN routing. What configuration should be made on the switch port that connects to the router?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A technician is programming switch SW3 to manage voice and data traffic through port Fa0/20. What, if anything, is wrong with the configuration?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
A network administrator of a college is configuring WLAN security with WPA2 Enterprise authentication. Which server is required when deploying this type of authentication?
IT Questions Bank 2IT Administrator asked 4 years ago • ,
What term describes adding a value to the packet header, as close to the source as possible, so that the packet matches a defined policy?
IT Questions Bank 2IT Administrator asked 4 years ago • 
A network engineer is troubleshooting connectivity issues among interconnected Cisco routers and switches. Which command should the engineer use to find the IP address information, host name, and IOS version of neighboring network devices?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
What are three characteristics of the CSMA/CD process? (Choose three.)
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Refer to the exhibit. How was the host route 2001:DB8:CAFE:4::1/128 installed in the routing table?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
« Previous1…103104105106107…167Next »
Ask Question