IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhat is a role of access points in an enterprise network?IT Administrator asked 3 years ago • CCNAWhat is a similarity between OM3 and OM4 fiber optic cable?IT Administrator asked 3 years ago • CCNARefer to the exhibit. What does the switch do as it receives the frame from Sales-4?IT Administrator asked 3 years ago • CCNARefer to the exhibit. Only four switches are participating in the VLAN spanning-tree process. Which switch becomes the permanent root bridge for VLAN 5?IT Administrator asked 3 years ago • CCNAWhen deploying syslog, which severity level logs informational message?IT Administrator asked 3 years ago • CCNARefer to the exhibit. An engineer must configure GigabitEthernet1/1 to accommodate voice and data traffic Which configuration accomplishes this task?IT Administrator asked 3 years ago • CCNAWhich technology is appropriate for communication between an SDN controller and applications running over the network?IT Administrator asked 3 years ago • CCNAWhich security program element involves installing badge readers on data-center doors to allow workers to enter and exit based on their job roles?IT Administrator asked 3 years ago • CCNAWhich network action occurs within the data plane?IT Administrator asked 3 years ago • CCNAWhich networking function occurs on the data plane?IT Administrator asked 3 years ago • CCNAA network administrator must to configure SSH for remote access to router R1 The requirement is to use a public and private key pair to encrypt management traffic to and from the connecting client. Which configuration, when applied, meets the requirements?IT Administrator asked 3 years ago • CCNAWhich protocol does an access point use to draw power from a connected switch?IT Administrator asked 3 years ago • CCNAWhat is the benefit of using FHRP?IT Administrator asked 3 years ago • CCNAA network engineer must configure the router R1 GigabitEthernet1/1 interface to connect to the router R2 GigabitEthernet1/1 interface. For the configuration to be applied the engineer must compress the address 2001:0db8:0000:0000:0500:000a:400F:583B. Which command must be issued on the interface?IT Administrator asked 3 years ago • CCNAWhat does an SDN controller use as a communication protocol to relay forwarding changes to a southbound API?IT Administrator asked 3 years ago • CCNA